Docomo Next N-04D, Инструкция по эксплуатации, Страница: 63 / 207

Getting Started
61
Again, keep touching the easy setup •
button until the POWER LED is lit Orange
on the access point.
When the status bar shows
• , you are
accessible to the Wi-Fi network.
WPS
■
Push Button Control method: Search for •
access points begins, so you should press
the pushbutton on an access point itself
or an access point’s setting screen.
Continue by following onscreen
instructions.
PIN method: Search for access points
•
begins. Continue by following onscreen
instructions. When "PIN code" (Pin code
for WPS) appears on the terminal, register
the displayed number in the access point.
When the status bar shows
• , you are
accessible to the Wi-Fi network.
If the security for a WPS-set access point
•
is WEP, connection is not possible.
Adding a Wi-Fi network manually
For information on using an access point,
⿟
refer to the manual for the access point.
1
From the Home screen,
m
▶
"Settings"
▶
"Wireless &
networks" ▶ "Wi-Fi settings"
2
Mark the "Wi-Fi" checkbox
3
"Add Wi-Fi network"
4
Enter the network SSID for the
Wi-Fi network to be added, and
then select the security (Open,
WEP, WPA/WPA2 PSK, 802.1x
EAP)
5
Enter additional security
information as required
▶
"Save"
Disconnecting a connected Wi-Fi
network
1
From the Home screen,
m
▶
"Settings"
▶
"Wireless &
networks"
▶
"Wi-Fi settings"
2
Tap the connected Wi-Fi network
▶ "Forget"
NOTE
Packet communication is still available when
⿟
Wi-Fi is turned on. However, if the terminal is
connected to a Wi-Fi network, the Wi-Fi network
takes precedence. When the Wi-Fi network is
disconnected, the terminal automatically
connects to the LTE/3G/GPRS network. If you
continue using the terminal connected to the
LTE/3G/GPRS network, note that you will incur
costly packet communication charges.