8-8-2006
Handleiding
EN STF V1.0
www.doco-international.com
21
24)
Placing the top panel:
-
Saw the top panel at the correct height.
-
Do not mount any finger guards (25700) on the top roller!
-
The top roller’s mounting to the top roller holder depends on how the door is driven
:
POSITION A = E-driven
POSITION B = Hand driven
25)
Mounting the cable and positioning the cable drum
-
Level the shaft.
-
Lead the cable (25111-3) of the bottom bracket (25029) behind the
shafts of the roller to the cable drum (assuming a 11001-11014 cable
drum is being used)
-
Slide the cable end through the cable fixing hole of the cable drum
(11001-11014) and turn the cable drum in such a way that the cable
is tensioned and that there is at least cable of ½ a winding** on the
drum; then mount the key (25064-25073) between shaft (25018-
25016) and cable drum (11001 -11014).
See figure on the right
** Equals 2 TÜV approved windings // Ref TÜV : BB-FTA-MUC/re-sc
30604_Besch_torque.doc
-
Align the cable drum (11001-11014 ) in such a way that it is possible to freely wind up the cable
(25111-..). Secure the cable drum ( 11001-11014 ) with the fixing bolts on the shaft between 27 –
maximum 34 Nm.
-
The cable fixing bolt must be tightened with 13 Nm.
Now block the shaft using the pinchers and secure the other cable the same way.
It is important that both cables are equally tensioned and that the door blade is balanced .
26)
Tensioning the torsion springs
Secure the door in such a way that it cannot go up. Fix the vertical tracks for instance with pinchers.
Tension the springs according to the following procedure.
The required number of turns of the spring is indicated on the labels of the assembled springs.
After tensioning, fix the spring fittings on the shaft with 27 up to 34 Nm (this applies both to spring fitting
12002-W and to spring fitting 12003-W.)
