Model1.gcode
Printing...
100%
Y: 20
62%
200/200℃
Z: 20
00:00:20
X: 20
60℃/60℃
Model1.gcode
Printing...
100%
Y: 20
62%
200/200℃
Z: 20
00:16:20
X: 20
60℃/60℃
15
Warning:
Operation steps:
2. Follow the steps below to execute the Gcode file.
Press the “
Entrance
to file directory interface
”
button
Note: 1. The U disk or microSD card format shall be Fat32 with the capacity not greater than 32GB.
1. Make sure the machine has been properly leveled and zeroed before executing any Gcode files. We strongly advice you to check if the zero point is suitable by moving the Z
coordinate to 0 manually and test the friction status with a piece of A4 paper.
3. Applying masking tape before printing can greatly reduce risk of getting the heated bed sticker scratched!
Switch to microSD
card or U disk
Press to select the
file you want to print
Press the “
File execution
”
button to start printing
Wait for the heated bed
and nozzle to be heated
to the target temperature
Start printing
automatically
1. Preheat nozzle and heated bed to target temperature, and test extrusion performance of the 3D print functional module. Refer to Section 3.3.
Files
文件名
.ggzed
........ .ggzed
.........
.........
.........
Files
文件名
.ggzed
........ .ggzed
.........
.........
.........
Files
文件名
.ggzed
........ .ggzed
.........
.........
.........
2. After printing finished, please wait until heated bed cools down to ambient temperature. Place a knife or spatula under the print and apply a small amount of force to
remove it. Do not try to drag or pull the print off, otherwise the heated bed sticker may swell and result in severe unevenness.
microSD card slot
Note:
The main control board is designed with microSD card slot. MicroSD card is neither
standardly equipped nor required. Format of microSD card you used shall be Fat32
with the capacity not greater than 32GB.
