- 27 -
English
Setup
Please follow those steps for connecting your radio to your network
Turn on the radio:
Plug the cable from the AC adaptor into the socket on the back of the radio, then switch on at the mains.
Only use the AC adaptor that supplied with the radio. Connecting a power supply with a dif-
ferent rating will cause permanent damage to the radio and may be hazardous.
The display on the front of the radio will light up and say:
Followed by:
If you listen to the Internet radio and Media player before you turned off the
radio, it will be automatically switched to Internet radio mode; Or if you was
listening to FM radio, it will be automatically switched to FM radio mode.
After a few seconds, this will change to show:
Connect to network:
If you make a mistake at any point, press the BACK button to go back to the previous screen.
At fi rst, you need to select network
;
Press the
SELECT
button.
Rotate the dial until the display shows
Confi gure.
Press the
SELECT
button.
Rotate the dial until the display says
Network Confi g
Press the
SELECT
button.
When the ESSID for the access point you want to connect to be displayed
on the screen, press the SELECT button. You might need to enter the
correct WEP(Wired Equivalent Privacy) or WPA(Wi-Fi Protected Access)
code.
If your network is not confi gured to need a WEP or a WPA code, the display
will show:
If the screen displays:
Then the network is using one of the encryption systems:
Wired Equivalent Privacy (WEP) or Wi-Fi protected Access (WPA). You
therefore need to enter the correct WEP or WPA code into the radio for it to
communicate with you network.
After 3 seconds the display goes into the code entry mode or press
SELECT
.
To enter the code, rotate the dial to select each character of the code in
Getting started
IPdiominiDEFV1.indd 27
IPdiominiDEFV1.indd 27
23.12.2013 15:24:15
23.12.2013 15:24:15
Содержание IP-dio mini
Страница 1: ...mini Bedienungsanleitung user manual Mode d emploi ...
Страница 37: ... 37 English ...