11
SL620A
Installation and Quick Start Guide
Quick Start
Chapter
3
Make sure all power supply cables (Printer, Router and DS-Tmini) are connected.
1)
Switch ON the DS620A printer.
NOTE:
Always power on the printer and the WIFI router first, before powering up the SnapLab Terminal.
2)
Load media into the printer (please refer to DS620A Quick Reference Guide).
3)
Switch ON the DS-Tmini (ON button is on the rear side).
NOTE:
After a few moments the Photo Editing Software will automatically start. The software will display
only products that can be printed with connected printer and loaded media.
If the DS620A Printer is not connected, the software will display the following message:
When the printer is connected to the system, the above message will disappear automatically within
a few seconds, and then the software will display the products window as per the connected printer.
1)
Enter into Main Panel by touching in sequence the
lower left and right
corners of the monitor.
NOTE:
Current versions of the SnapLab will allow the settings menu to be password protected, refer to the user manual enable this function.
Starting SL620A
Change of software language by default