DMT 100801, Руководство пользователя

Страница: 19 / 27

17
Example 2
Power-on command of the projector is POWR___1 (Enter)
(_ signifies space)
Then in the command field should contain: \50\4f\57\52\20\20\20\31\0d (upper/lower case is
insensitive).
Also see the ACII table in appendix 3.
Infrared remote control
If it is impossible to obtain the Control Code of a projector, but the projector can be controlled by
infrared control, please select the “Infrared Remote Control” button. See figure 22.
Fig. 22
Make an “Infrared Learning Cable” (see appendix 1) and connect the wire as shown in figure 7 on
page 9.
The system shall pickup the infrared code of the projector via infrared receiving window on the control
panel of the host.
The computer shall process the infrared code and send out the infrared signal to the infrared receiving
window of the projector through the infrared LED, connected to the wire. You can observe the action of
the projector to verify the correctness of the infrared code.
Please note the following :
Construct an Infrared learning cable according the figure in appendix 1.
The infrared diode should be connected to pins 3/5 and correspond with Anode (+) and
Cathode (-) respectively.
Please place the Infrared LED next to the Infrared receiving window of the projector.
Attention
Please confirm that the power supply of the projector is kept on during the infrared study.
Before executing a certain function, confirm that the projector is ready to receive infrared signals.
After confirmation of the correct connection, turn on the computer and run the setup program to reach
the screen shown in figure 22. Aim the remote control of the projector at the receiving window of the