DMP Electronics 734B, Инструкция по установке и программированию

Страница: 21 / 36

Digital Monitoring Products, Inc. | 734B Installation and Programming Guide 17
PROGRAM THE 734B
When you program a 734B, you can use a keypad connected to the 734B programming
header and set to address 1. For 12 V applications, connect the keypad to the module
using a Model 330 4‑wire harness. For 24 V applications, connect the keypad to the
module using a Model 330‑24 4‑wire programming harness with in‑line resistor.
Caution:
Do not connect a keypad using a standard Model 330 harness if using a
24 V power supply! Damage to the keypad could occur.
You can also program the 734B from an XR150/XR550 Series panel. If you choose to
program the 734B from the panel, all future programming should be performed through
the panel. The panel’s programming overrides any programming performed from a
keypad connected to the 734B. While the 734B is in programming mode, it will not be
able to communicate with the panel.
You can complete the following programming steps with Dealer Admin, Entré, locally
from a keypad connected to the 734B, or from the panel.
Note: If you program BINs from the panel or Dealer Admin, formats used by the
module will be subtracted from the total number of available formats for all
connected 734B modules. BINs longer than 6 digits cannot be programmed from
Dealer Admin.