2
12/13 REV. G FILE #: SCTP-DS
COPYRIGHT © 2010 Daniels Manufacturing Corp ALL RIGHTS RESERVED
DANIELS MANUFACTURING CORP. 526 THORPE ROAD, ORLANDO, FL 32824, USA
PHONE (407) 855-6161 • FAX (407) 855-6884 •w ww.DMCTools.com • E-MAIL: [email protected]
FIGURE 2
NOSE ASSEMBLY
NOSE ADAPTOR
8-32 SOCKET HEAD CAP
SCREWS
FIGURE 3
MOUNTING HOLE
MOUNTING HOLE
TORQUE WRENCH (lb.
in)
LEFT
SWIVEL
LEVER
RIGHT SWIVEL
1.1.4.
Place a calibrated 3/8" drive torque wrench (Daniels SCTD0001) into the square drive hole, orient-
ing the torque verification block and torque wrench on a flat surface as shown in figure 2. Apply the
proper pull-off load as shown in table 2.
CAUTION: RELEASE TORQUE WHEN MINIMUM PULL-OFF IS ACHIEVED.
DO NOT APPLY ADDITIONAL TENSION TO THE CABLE.
1.1.5. If the cable did not break or pull out of the ferrule after applying proper torque, remove the torque
wrench and apply approximately 2 lb force to the cable with your finger (or Daniels SCTD013) at
the line marked "TEST AREA".
1.1.6. If the cable breaks or pulls out of the ferrule, or it touches either the side or bottom surface of the test
area, then the crimp is unacceptable and the tool indenter should be adjusted per section 1.2.
1.2 INDENTER ADJUSTMENT
1.2.1. Remove the nose assembly by removing the two 8-32 socket head cap screws as shown in figure 3.
1.2.2. Loosen the pushrod lock-nut using the SCT32084 adjustment tool as shown in figure 4A.