HDE51C-DS
©2022 DANIELS MANUFACTURING CORP., ALL RIGHTS RESERVED
Page 5 of 8
REV. A
7/26/2022
Daniels Manufacturing Corporation
526 Thorpe Road, Orlando, FL 32824 USA
Phone: 407-855-6161 Fax: 407-855-6884 Email: [email protected]
HDE51C
BATTERY POWERED CRIMP TOOL
DATASHEET
Trouble Shooting
Before You Begin
1.
Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
2.
Use a nonflammable contact cleaner or pencil
eraser to clean the electrical contacts on the
battery and crimp tool.
3.
Reinstall the battery and check the tool again.
Problem
Probable Cause
Probable Remedy
Tool is inoperative Dirt, contaminants, etc,
Clean tool.
in ram area of tool.
Crimping tool battery
Reform contacts.
contacts damaged.
Tool components worn or
Return tool to DMC.
damaged.
Dies stop during
Oil level is low.
Return tool to DMC.
operation.
Air in hydraulic system.
Pull trigger and hold
emergency release
button simultaneously.
Hold for approximately
10 seconds.
Tool loses oil.
Damaged internal seal.
Return tool to DMC.
Gaging the crimp tool
The crimp should be gaged periodically to ensure that
proper crimping is being performed. Intervals between
checks should be determined by the customer based on
tool use and environment the tool is used in.
Gaging Instructions
1.
Install die set as previously described.
2.
Activate tool, to close die set fully. Release trigger
before tool achieves full pressure and pops off.
The die set will remain closed.
3.
Use the appropriate GO/NO-GO gage for the die
set being used.
Battery Charger Operating Instructions
Operating Environment
The charger is designed for use in dry areas. All ventilation
slots must be kept free. If possible, keep away from heat
sources and out of direct sunlight as ambient temperatures
in excess of 95°F (35°C) may increase charging times
significantly.
AC Connection
Before connecting the charger, check that the AC supply
voltage is the same as what is indicated on the charger.
Specifications
Frequency=50Hz to 60Hz
Output Voltage=7.2 to 18VDC
Weight=2.2lb(1.0kg)
Safety Instructions
The charger is designed only for Li-ion and Ni-MH batteries
with voltages ranging from 9.6VDC to 18VDC and capacities
from 1.7Ah to 3.0Ah.
1.
Before you use the charger, check the power
cord, extension cable and connectors for any
signs of damage or aging.
2.
Do not open up batteries or the charger. Do not
puncture or expose to heat as there is RISK OF
EXPLOSION.
3.
Only store in dry areas. Protect from moisture
and dampness.
4.
Do not use if the charger is defective and
never insert defective batteries.
5.
Observe the symbols on the charger’s rating plate.
6.
Do not throw old batteries into the fire or dispose
of as domestic waste.
7.
Keep metal objects that could cause shorts
away from the charger.
8.
Do not dismantle the charger or batteries.
Operation
Green LED
If the charger is connected to the AC line the green LED will
flash repeatedly until a battery is installed for charging.