AFE8B
BATTERY POWERED CRIMP TOOL
DATASHEET
________________________________________________________________________________________________
AFE8B-DS
©2012 Daniels Manufacturing Corp., All Rights Reserved Page 6 of 7
REV. D
6/20/2014
Daniels Manufacturing Corporation
526 Thorpe Road, Orlando, FL 32824 USA
Phone: 407-855-6161 Fax: 407-855-6884 Email: [email protected]
Specifications
Frequency=50Hz to 60Hz
Output Voltage=7.2 to 18VDC
Weight=2.2lb(1.0kg)
Safety Instructions
The charger is designed only for Li-ion and Ni-MH batteries
with voltages ranging from 9.6VDC to 18VDC and capacities
from 1.7Ah to 3.0Ah.
1.
Before you use the charger, check the power cord,
extension cable and connectors for any signs of
damage or aging.
2.
Do not open up batteries or the charger. Do not
puncture or expose to heat as there is
RISK OF
EXPLOSION.
3.
Only store in dry areas. Protect from moisture and
dampness.
4.
Do not use if the charger is defective and never
insert defective batteries.
5.
Observe the symbols on the charger’s rating plate.
6.
Do not throw old batteries into the fire or dispose of
as domestic waste.
7.
Keep metal objects that could cause shorts away
from the charger.
8.
Do not dismantle the charger or batteries.
Operation
Green LED
If the charger is connected to the AC line the green LED will
flash repeatedly until a battery is installed for charging.
Charging a Battery
When a battery is inserted on to the charger the red LED will
illuminate and stay on while charging occurs.
The green LED will turn off while the battery is less than
80% charged.
Both green and red LED’s will illuminate when the battery is
greater than 80% charged, but not yet fully charged.
When charging is complete, the red LED will turn off, and
the green LED will stay on.
If you leave the battery on the charger after it is charged,
the charger will switch to its trickle charge mode for 24
hours.
The following are the possible conditions shown by
the right hand yellow LED.
Flashing indicates trouble with the cooling fan system.
Ensure that all cooling vents, and the battery connections
are free of dust or debris. If flashing continues, return the
unit to DMC for repair.
Continuous illumination indicates that a conditioning charge
is occurring. This happens when the battery being charged
is at either a very low or very high temperature. This can
also occur if you attempt to charge a fully charged battery.
These conditions will increase charging times.
Other conditions indicated by charger LED’s
Flashing Red with Green off
-Charger is overheated.
Unplug the charger, and allow it to cool down.
Flashing Red, with Flashing Green
-This indicates a
defective battery.
Spare Battery Parts
120 VAC Battery Charger
HDE-LI-120C
230 VAC Battery Charger
HDE-LI-230C
18V Replacement Battery
HDE-LI-B
120 VAC Power Adapter
HDE-120AC-A
230 VAC Power Adapter
HDE-230AC-A
