DK2 Power OPC525, Руководство пользователя

Страница: 28 / 68

28 | OPC525(D) man.
TROUBLESHOOTING
Most problems are easy to fix. Consult the troubleshooting table below for common problems and
their solutions. If you continue to experience problems, contact the DK2 Customer Service Team
at 1 (888) 277-6960 or contact us via our website at www.dk2.com.
TROUBLESHOOTING TABLE
SYMPTOM POSSIBLE CAUSE
The engine won’t start
(please refer to the engine
User Manual for engine-specific
procedures.)
• Is the shut off valve on? Slide the lever all the way to the right.
• Are you using fresh, clean gas? if the gas is old, change it. Use a
fuel stabilizer if you keep gas longer than 30 days.
• Is the spark plug clean? if the spark plug is dirty or cracked, change
it. If it’s oily, leave it out, hold a rag over the plug hole and pull the
recoil cord several times to blow out any oil in the cylinder, then
wipe off the plug and reinsert it.
The engine lacks power or is not
running smoothly.
(please refer to the engine
User Manual for engine-specific
procedures.)
• Check that the throttle lever is in the “RABBIT” position. Turn off
the choke.
• Is the air filter clean? If it’s dirty, change it following the procedure
in the engine manufacturer’s Owner’s Manual.
• Is the spark plug clean? If it’s fouled or cracked, change it. If it’s
oily, leave it out, hold a rag over the plug hole and pull your recoil
cord several times to blow out any oil in the cylinder, then wipe off
the plug and reinsert it.
• Are you using fresh, clean, unleaded gas? If it’s old, change it. Use
a fuel stabilizer if you keep gas longer than 30 days.
• Does your engine have the right amount of clean oil? If it’s dirty,
change it following the procedure in the engine manufacturer’s
Owner’s Manual
Engine smokes.
(please refer to the engine
User Manual for engine-specific
procedures.)
• Check the oil level and adjust as needed.
• Check the air filter and clean or replace if needed.
• You may be using the wrong oil - too light for the temperature.
Refer to your engine manufacturer’s Owner’s Manual for detailed
information.
• Clean the cooling fins if they’re dirty.
Machine does not seem to have
full chipping power.
• The belt may be too loose and slipping. Adjust or replace belt as
needed.
• The blades may be dull, reverse to the sharp edge or replace
blades.
• Check drum for blockage.
ENGLISH