9
Assembly
Assemble the Front Wheel to the Fork
1. If the Axle Nuts (A) are already attached to the front wheel axle, begin by remov-
ing them with an open end wrench or adjustable wrench.
2. Set the wheel into the front fork (B).
3. Install Step Washers (C) making sure the small end goes towards the fork Indent
(D).
4. If installing Axle Pegs (E), follow instructions on pages
27
and
28
.
5. Attach the front wheel with the Axle Nuts.
6. Tighten Axle Nuts to 21 ft-lbs (28.4 N•m).
B
C
A
D
A
C
E
G
F
NOTE:
Some models may have Wheel Retainers (F)
instead of Step Washers (C). Install Wheel Retainers
(F) making sure the Tabs are in the Fork (G) Tab Holes.
NOTE:
Ensure wheel spins freely without contacting
fork or fender.
WARNING:
Do not use Nuts (A) without serra-
tions to attach the front wheel.
WARNING:
Put the wheel in the center of the fork
and tighten both nuts to the recommended torque of 21
ft-lbs (28.4 N•m)
WARNING:
Failure to obey these steps can allow the front wheel to loosen
while riding. This can cause injury to the rider or to others.
