28
Accessories
Pegs Installation - Bolt on
NOTES
• Front and rear pegs may be different sizes.
• The pegs are optional. You may choose not to install them on the axles. Pegs can
be installed on the front, rear or on one side.
• The same procedure is used to install pegs on both the front and rear axles. Front
wheel axle is shown.
Pegs that are not threaded:
•
A socket wrench, a metric socket which fits the axle nuts, and a three-inch socket
extension are necessary to install the pegs.
•
Remove the Axle Nuts (A) if previously installed when attaching wheel to Fork (B)
• Install Step Washers (C) making sure the small end goes towards the fork Indent
(D).
• Put a Peg (E) on each end of the axle.
• Put an Axle Nut (A) down inside each peg, and onto the end of the axle. Ensure the
serrated side (F) of the Axle Nut is toward the wheel.
• Put the wheel in the center of the fork or frame and tighten both nuts to the recom-
mended torque of 21 ft-lbs (28.4 N•m).
C
B
A
F
E
D
WARNINGS:
• Do not use Axle Nuts (A) without serrations (F) to attach the wheels.
• Do not ride beyond your capabilities.
• Pegs should be installed by an adult.
• Check before each ride.
• Ensure there is no damage to frame, fork or wheels during install and use.
• Ensure chain is properly adjusted after install.
• Ensure wheels are properly aligned after install.
• If damaged, stop use and replace.
• Failure to obey these steps can allow the front wheel to loosen while riding. This
can cause injury to the rider or others.
NOTE:
Some mod-
els may have Wheel
Retainers instead of
Step Washers. Install
Wheel Retainers
making sure the Tabs
are in the Fork Tab
Holes (
view D
).
