©2013 DJI Innovations. All Rights Reserved.
10 |
TransmitterOperation Mode
Definitions
”
Stick neutral position and stick released means the stick of Transmitter is pushed to the central position.
”
Command Stick means the stick of Transmitter is pushed away from the central position.
Transmitter
(Mode 2)
Aircraft
is the nose direction
Operation Mode details
The throttle stick is for aircraft up& down control.
The aircraft will hold the height automatically if the stick is
centered. You should Push the throttle stick to the neutral
position to take-off.
The yaw stick is for aircraft rudder control.
The command stick controls the angular velocity of the
aircraft, with the maximum rudder angular velocity of
200°/s. The left stick command gives counter clock-wise
rotation of the aircraft, & vice versa.
The roll stick is for aircraft left/right control and pitch stick
is for front/back control. The command stick controls the
angle of aircraft.The stick neutral position is for
0˚, its
endpoint is 35˚. The roll and pitch sticks return to the central
position when released.
”
In GPS Mode, the aircraft will hover (hold horizontal
position) when sticks released.
”
In ATTI. Mode, the aircraft will keep attitude stabilizing
without horizontal position (different from hover in GPS
Mode).
GPS ATTI. ATTI. ATTI.
(
Manual or
Failsafe is
selectable
in
software.)
3-position switch (S1) on the Transmitter for mode control.
Only after Compass Module connection and Compass
calibration, GPS ATTI. Mode is available. Otherwise, all
switch positions are for ATTI. Mode. Pay attention because
the GPS ATTI. Mode is dependent on the number of
GPSsatellites acquired by the main controller. Refer to the
LED Indicator. When GPS signal has been lost for 3s, system
enters ATTI. Mode automatically. You can enable the Manual
Mode or FailSafe (also known as One-key Go-home) in the
assistant software->Basic->R/C->Control Mode.
OFF Course Lock Home Lock
3-position switch (S2) on the Transmitter for Intelligent
Orientation Control (IOC). Set the switch to OFF in basic
flight.This function is defaulted to off. If you want to use this
function refer to the advanced manual, and enable it in the
assistant software. Use IOC when you are familiar with basic
flight.
