©2014 DJI. All Rights Reserved.
46
7.
Q: Aircraft enters failsafe when using DJI LIGHTBRIDGE air system.
A: Calibrate remote control through DJI LIGHTBRIDGE Assistant after connect the remote control to
ground system. Fine tune the End Point value for channel U.
8.
Q: Can we install two air systems on the same aircraft?
A: No.
9.
Q: My on-board camera has WiFi and Bluetooth function, can I turn them on during the flight?
A: No, ensure that you have disabled WiFi and Bluetooth on your camera, otherwise it may interfere air
system transmission.
10.
Q: How to improve GPS searching time?
A: Check if HDMI cable stays too close to the GPS module. Maintain 15cm distance between HDMI
cable and GPS module.
11.
Q: Air system VIDEO indicator turns solid red when connecting with BMPCC gimbal, is that normal?
A: BMPCC gimbal has its own encoding system, therefore it does not rely on air system for encoding.
Hence air system VIDEO indicator blinks green is work as design.
12.
Q: Green lines appear on screen.
A: Check if the output resolution or format is supported by DJI LIGHTBRIDGE.
13.
Q: Green lines appear on screen. Air system VIDEO indicator blinks red after rebooting and also no
video output from ground system, what should I do?
A: Air system VIDEO indicator blinks red indicating no video output or unsupported video output
format. Check the following to resolve this issue:
a)
Check if the on-board camera is powered on. Connect the camera to a display device to check
whether the signal output is normal. If video output is normal, check whether the video output
format is supported by DJI LIGHTBRIDGE.
b)
Examine the HDMI cable condition, should the condition of the HDMI cable is not mint, replace
the HDMI cable.
c)
Contact DJI technical support team if the problem persists.
14.
Q: Ground system CONTROL LED blinks green.
A: Blinking green indicator means linking is required. Check the follow to ensure linking is carried out
correctly.
a)
Antennas are firmly attached on both air system and ground system.
b)
Launch DJI LIGHTBRIDGE App to check whether ground system is in master mode, if not,
