46
47
5
4
Fit loops on harness ends
onto the splitter plate.
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar, BETWEEN metal
bar and plastic handle of
the harness/headrest
adjuster.
WARNING
!
Reinstall Base:
Remove bar from base.
Line up shell with base.
Begin with the rounded
end, push bar completely
through hole, starting on
the right side
(A)
, until it
locks in place. Refer to
“Removal of Seat Base”.
6
A
Failure to place harness over the metal bar,
between bar and plastic handle of the
harness/headrest adjuster in back, can
result in serious injury or death.
Thread the harness down
through slot on left side of
shell
(1)
, across bottom of
seat
(2)
and up through
slot on right side
(3)
.
Thread one latch plate
onto harness from back to
front
(4)
.Thread the
harness retainer
(5)
. Do
the same to the other
harness end. Make sure the
harness is not twisted.
Push harness ends through
upper slots in shell
(6)
.
4
WARNING
!
Failure to reattach the harness correctly,
can result in serious injury or death.
1
2
3
4
5
6
4358-3340E Elite_Lux 2/23/09 1:45 PM Page 49
