DISASSEMBLY TOOLS:
If the grinder is not located on floor level
make no attempt to disassemble the grinder
unit without an adequate platform or
provisions provided by the installation
contractor, plant engineer, or plant safety
officer. The grinder has many parts that
have square edges and cutting edges.
Adequate safety equipment should be used at
all times!
After the grinder has been installed in its
permanent position, it can be disassembled.
The tools described below are for both
disassembly and assembly of the grinder
unit.
Ring Wrench
The Ring Wrench fits over the lugs of ring
and is used to loosen the ring (counter
clockwise), or tighten the ring (clockwise)
The end of the ring wrench fits into the end
of the feedscrew and it can be used to engage
the feedscrew to the drive spline.
Plate Lifter
This is used to
remove the plate
and bushing from
the grinder unit, or
on assembly to
install the plate and
bushing into the
grinder unit.
Note:
Wear appropriate safety equipment and
remember to always "Work Safely".
GRINDER UNIT DISASSEMBLY:
READ AND UNDERSTAND THE
FOLLOWING TAG.
When the grinder unit has been properly
secured, disassembly can begin.
Step 1. Using the ring wrench, loosen the
ring by exerting downward pressure, turning
the ring counter clockwise.
Step 2. The ring
lift supports the
weight of the
ring. Turn the
ring on and off
very slowly to
prevent the
treads from
galling.
7
