Step 6. INSTALL SPRINGS.
The Belleville springs are installed with one
spring facing down, and the second facing up
toward the back surface of the knifeholder,
which will be installed next.
Step 4. INSTALL FEEDSCREW.
Using the Model FSP2009 feedscrew puller,
or other device, install the feedscrew into the
grinder unit. Do not attempt to install the
feedscrew by hand, or by yourself. You will
notice that when using the FSP2009 the
feedscrew usually engages on the drive spline
with little effort. If you are not using the
FSP2009 it will be necessary to use the
handle end of the ring wrench.
When using the ring wrench to install the
feedscrew, lift the feedscrew slightly while
pushing it in.
If the feedscrew does not slide up on the
spline, it may be necessary to push down, in,
while turning the feedscrew slightly to
engage the drive spline. B drives engage
much easier than the older A drives. The
feedscrew will jump in another inch when it
is seated on the spline.
Place the pin key into the slot in the centering
pin.
Insert the pin in the pin hole of the
feedscrew. As you push the pin in, line up
the key with the keyway. The pin bottoms
out in the hole in the feedscrew. The pin
should slip in by hand! If it does not check
the pin hole for nicks and foreign material.
Step 5. INSTALL CENTERING PIN.
Inspect the pin to make sure it is clean and
free of nicks and burrs. Replace the pin
when it shows wear grooves, checks, or is
worn.
13
