ASSEMBLY TEMPLATE
REVISION LEVEL
EMK
11/14/16
CREATED DRAWING
REV.
A
-
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
300 South Krueger Street
Suring, WI 54174
diversifiedwoodcrafts.com
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
ADA INSTRUCTOR DESK
ADA INSTRUCTOR DESK
ASSEMBLY INSTRUCTIONS
REV A
5 OF 7
NTS
EMK
11/14/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 4:
APPLY SILICONE ADHESIVE TO TOP EDGES OF CABINETS AND APRON.
PLACE TOP ON UNIT WITH PROPER OVERHANG (1" OVERHANG ON
SIDES AND 1.50" ON FRONT AND BACK). CLAMP ON TOP TO TOP RAILS
OF CABINETS AND APRON TO REMOVE ANY WARP USING SHIMS AND
C-CLAMPS, IF NEEDED, WHEN ALIGNING THE TOP (DO THIS BEFORE
ADHESIVE ON EDGES SETS UP). LET CURE FOR 6-12 HOURS.
TOP VIEW OF INSTRUCTOR'S DESK SHOWN
TOP VIEW OF INSTRUCTOR'S DESK SHOWN
STEP 5:
APPLY SILICONE ADHESIVE TO THE SINK OPENING ON TOP. LOWER SINK
INTO OPENING. WIPE OFF ANY EXCESS CAULK AND ALLOW TO SET. LET
CURE FOR 6-12 HOURS.
STEP 6:
ATTACH RUBBER MOLDING TO BASE OF INSTRUCTOR'S DESK USING
CONTACT CEMENT. AFTER MOLDING IS IN PLACE, SCREW STAINLESS
STEEL CORNER BRACKETS ON EACH CORNER OVER BASE MOLDING
WITH THE SCREWS PROVIDED. INSTALL MULTI-SERVICE FIXTURE IN THE
HOLE PROVIDED ON TOP. INSERT ROD SOCKET INTO PRE-DRILLED HOLE
IN TOP. SEE NEXT SHEET ON HOW TO INSTALL UPRIGHTS AND CROSSBAR.
NOTE:
1.
ALL WATER, ELECTRICAL, AND GAS CONNECTIONS SHOULD BE
PERFORMED BY A TRAINED PROFESSIONAL PER LOCAL CODE.
COMPLETE UNIT SHOWN
MULTI-SERVICE
FIXTURE
ROD
SOCKET
APPLY RUBBER
MOLDING HERE
TOP
APPLY SILICONE ADHESIVE
HERE FOR SINK
APPLY SILICONE ADHESIVE
TO TOP EDGES OF CABINETS
AND APRON
K:\DIVERSIFIED\ASSEMBLY INSTRUCTIONS\ACAD\1214K-L & R-ADA & 1216K-L & R-ADA SERIES.dwg, 12/2/2016 11:43:58 AM, DWG To PDF.pc3
