diversey TASKI vacumat 44T, Инструкция по использованию

Страница: 51 / 236

50
Application technique
Beginning work with the machine
Dry and wet vacuuming
Notice:
Do not vacuum objects such as screws and other
metal parts or objects that may cause damage to
the machine!
Notice:
When the nominal consumption is reached while
wet vacuuming, the float will cut off the air suction.
No more liquid will be vacuumed and the machine must
be turned off and emptied.
Conclusion operation
Wet vacuuming
Dry vacuuming
Notice:
The soiled solution that has been picked up must
be disposed of in compliance with the national reg
-
ulations.
Notice:
The machine may only be used with a fully function
-
ing filter cloth!
Replace heavily worn or defective filter cloths.
Tilt function
Carry function
Cleaning the float housing
Notice:
This machine must never be operated without the
coarse filter.
Machine vacumat 44T
Wet cleaning yes
Dry cleaning yes
Cleaning parquet and laminate floors no
• Connect the plug to the mains socket and press the ON/
OFF switch.
• Lift and push the Fixomat squeegee holder to the stop at
the rear and lower the Fixomat squeegee.
The Fixomat squeegee is in the parking position.
•
• Press the locking device on the intake and remove the suc
-
tion hose.
• Loosen the fixation knobs on the squeegee.
• Remove the squeegee from the squeegee support.
• Clean the Fixomat squeegee with water using a brush.
• Lift off the vacuum lid and remove the float insert.
• Firmly hold the ring of the filter cloth
with one hand.
• Hold the shackle on the base of the
filter cloth with the other hand and
shake it lightly.
In this way, the dust will fall to the
base of the tub without becoming
stirred up.
• Vacuum off the filter cloth using another vacuum cleaner.
• Hold the chassis and slowly tilt the
tank to empty.
• Push the levers that connect the tub
to the tilting frame outwards.
• You will now be able to lift the tank
from the frame and empty it.
• Rinse out the tank and the float insert.
The float insert must be maintained after every use.
• Re-assemble the machine.
• Remove the coarse filter (black) and
wash it out under running water.
• Unscrew the wing nut. The float can
now be pulled from the threaded rod.
Thoroughly clean the float and the
valve.
• Check that the float is not damaged.
• Push the float over the threaded rod and retighten the wing
nut.
• Check:
- that the float can be moved up and down easily.
- that the float covers the suction air inlet completely.