- 33 -
0DT829 2016-04-01
Correctly size the line conductor cross-section by referring to the indicated absorption and taking the length and
installation of the cables into account.
0 1
Tx1
Rx1
0 1
0 1
Tx2
Rx2
0 1
A935G/E
A935L
7982 7982
A451L
A934E/L
A933A - 7823B A931C - 7824B
7825A - C
7823A 7824A 7824A
7825A
7823C/D
7824C/D
7824C/D
9038 9036 9040 7825A - C
ENC M
F
T
Black Blue
Black Blue
Black Blue Orange Red
Black Blue Orange Red
C T
19
17
18
400 V
400 V
400 V
230 V
Inverter
230 V
Inverter
TRAFFIC C
Ø 33 mm
4. ELECTRICAL CONNECTIONS
4.1 Electrical panel
• Insert the cables with the pre-wired terminal boards in the housing. If not present, make a hole (drill with Ø 33 mm
fig. 17
)
and connect them to the boards (as shown in
chap. 5
). Fit the cables in the conduit and connect the connectors on the motor
(
fig.18
).
4.2 Electrical panel/motor/safety device connections
• Figure 19 shows the layout of the cables supplied and their position in the door; each cable is identified by a special code
on an adhesive label.
4.3 Safety photocells
• Make the electrical connections as shown in (
fig.19
).
• Make the connections in the control panel as shown in the diagrams in
chap. 5
.
EN
