Dish TV AerialBox ultra T1050PVR, Руководство пользователя

Страница: 29 / 33

Firmware Upgrade
If the firmware upgrade was incorrectly place on the USB it will also come up with the “Searching USB Memory Stick...”
message, the difference is the next message will say “SW Image is not present” it will then quickly display the Flash
Verification screen which will last only a few seconds. If this happens double check to see if the firmware files are
correctly in a folder called
DISHTV_7167
on your USB drive.
S/W Upgrade OTA:
This is Software Upgrade over the air. This will only work if the upgrade is being
broadcast. It can be selected from the “Installation” option in the Main Menu.
Via USB:
One way to perform a firmware upgrade on your receiver is via USB using the USB port in the back.
To do this just follow the instructions below...
1. Download firmware from www.dishtv.co.nz and follow the intructions on the website.
2. Unplug your aerialBox-Ultra from the power, insert the flashdrive.
3. Hold down the INFO button(or OK button if availible) on the front of the unit while pluging the power back in, keep
the INFO button held down until the unit says USB on the front panel. Then you can let the info button go and let the
unit load the firmware.
The receiver will first display “Load” and if done correctly the display on the front will show “USB” after about 3 seconds.
On screen at the same time it will present a window headed “Software Update through USB”
If the upgrade has been loaded correctly onto the USB flashdrive it will come up with ”SW Image File Reading in
progress...” straight after it displays “Searching USB Memory stick...”
Then to a couple of loading screens which will take about 3 minutes to complete.
29