Dish Network ViP 211k, Руководство пользователя

Страница: 55 / 122

Chapter 9
48
Changing the Address
C
HANGING THE
A
DDRESS
Use the following procedures to change the remote control address.
1
Press SYSTEM INFO on the receiver's front panel. The System Information screen
displays and shows the Remote Address.
Write down the address shown:
2
Press and hold SAT on your remote control for about three seconds, until all of the mode
buttons light up, and then let go of SAT.
3
Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote
in step 1.
4
Press POUND (#). If you entered the address correctly, SAT will flash three times.
Write down the number you entered:
5
Press RECORD. Make sure the Remote Address you see on the System Information
screen is the same as the one you entered in step 3. If it isn't, the remote cannot control
the receiver.
6
Press SELECT to close the System Information screen.