6
108933
C
HECK THE
D
EVICE
C
ODES
You can find out what device code you’ve set for each remote control
mode. Here’s what to do:
1. Press and hold the mode button for the device, for about three
seconds. When all the other mode buttons light up, let go of the
mode button.
2. Press the
Pound
(
#
) button twice.
The mode button flashes the number for each digit of the device
code, with a pause between the groups of flashes. A quick flash
is for zero. For example, the mode button flashes five times,
pauses, flashes seven times, pauses, and flashes once quickly
for the 570 code.
C
HANGE THE
A
DDRESS
Because UHF signals travel long distances and go through walls,
a neighbor’s remote may control your receiver by mistake.
To handle this problem, you can change the remote address.
Note:
Here we show you examples of the receiver’s front panel
buttons. Your receiver’s buttons may look a bit different.
1. Open the
Important System Information
menu.
To do this, first make sure you turn the TV on.
Next, press the receiver’s front panel
Power
button
to turn the receiver off. Then, press the receiver’s
front panel
Info
button. (Please don’t use the remote
control’s buttons because they might control your
neighbor’s receiver.)
2. The
Important System Information
menu
shows a
Remote Address.
Write down this number: _______.
3. Press and hold the
Sat
mode button about three
seconds, until all the mode buttons light up,
and then let go of the
Sat
button.
(please go on to the next page)
text_dishpvr.fm Page 6 Thursday, July 12, 2001 10:02 AM
