Dish Network HD34-310, Руководство пользователя

Страница: 39 / 57

Chapter 4
Installation and Setup
Page 35
Installation Considerations
Protect Against Power Surges
• Connect all components before you plug any of their power cords into the
wall outlet.
• Turn off the monitor and/or component before you connect or disconnect
any cables.
• Make sure all antennas and cables are properly grounded. Refer to the
Safety Instructions on page iii.
• To protect audio amplifiers of the monitor or connected audio equipment,
ensure the volume is turned down before powering up the system.
Protect Components from Overheating
• Don’t block ventilation holes on any of the components. Arrange the
components so that air can circulate freely.
• Don’t stack components.
• When you place components in a stand, make sure you allow adequate
ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so
the heated air from it won’t flow around other components.
Position Cable Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the monitor, route all cables down the side
of the back of the monitor instead of straight down the middle of the
monitor.
• If your antenna uses 300-ohm twin lead antenna cables, do not coil the
cables. Also, keep the twin lead cables away from audio/video cables.
Important Stand and Base Safety Information
Choose the location for your monitor carefully. Place the
monitor on a stand or base that is of adequate size and strength
to prevent the monitor from being accidentally tipped over,
pushed off, or pulled off. This could cause personal injury and/
or damage the monitor. Refer to the Safety Instructions.
Use Indirect Light
Don’t place the monitor where sunlight or room lighting will be directed
toward the screen. Use soft or indirect lighting.
Magnet Warning
Don’t place large speakers or subwoofer close to the monitor or the picture
can become permanently distorted.