![Dish Network DISH 1000.2 Скачать руководство пользователя страница 8](http://html1.mh-extra.com/html/dish-network/dish-1000-2/dish-1000-2_installation-manual_2509015008.webp)
Page 7
From the
Point Dish
screen, run
Check Switch
. On Legacy receiver models 2800, 3900, 4900,
and 6000, select the
SuperDISH Installation-3Sat
option prior to running the Check Switch test.
On all other Legacy models, select
Test
. When the Check Switch procedure finishes, you should
see an Installation Summary screen similar to the ones shown below. Make sure the summary
screen shows reception from the 119°W, 110°W, and 129°W satellites on all available satellite
tuners. Also confirm the LNBF is correctly identified as a
DPP 1000.2
(factory software on
some models may identify this LNBF as a
DPP Twin
or
DPP Triple
, which is OK). Legacy
receivers will identify the LNBF as
SW64
.
Note
:
On some models, you might not see signal from 129°W until after you take a software
download and run a Check Switch in steps 10 and 11. Legacy receiver models 1000, 2000, 3000,
4000, 5000, 7100, 7200, and JVC-DVHS (IRR) may not detect and will not support the 129°W
location.
Note
: If you are using the Three-LNBF Bracket, your Installation Summary screen will vary
depending on the connected switch. Make sure the summary screen shows reception from the
119°W, 110°W, and 129°W satellites on all available satellite tuners.
Exit the
Installation Summary
screen to display the
Point Dish/Signal
screen. Make sure the
signal strength bar is green and locked for the 119°W, 110°W, and 129°W satellites.
Note
: You might not see signal from 129°W until after you take a software download and run a
Check Switch in steps 10 and 11.
Exit the
Point Dish/Signal
screen and follow the on-screen instructions for taking a receiver
software download. Do not disturb the receiver during the process of downloading software. If
exiting the
Point Dish
screen does not start the download process, turn off the receiver for at
least 20 minutes (on most receivers) to allow the receiver to take a software download.
Run
Check Switch
again and confirm reception for all three satellites on all available satellite
tuners. Your Installation Summary screen should be similar to the ones shown above in step 8.
Some software on some models may identify the DPP 1000.2 LNBF as a
DPP 1K.2
. This
identification is OK.
If installing an additional receiver, follow steps 6-11. Make sure the summary screen shows
reception from the 110°W, 119°W, and 129°W satellites. Keep in mind that a DISH Pro or DISH
Pro Plus receiver must remain connected and powered at all times to power the DPP 1000.2
LNBF.
DISH Pro/DISH Pro Plus Legacy
Installation Summary Installation Summary
Содержание DISH 1000.2
Страница 21: ...Page 20 Notes ...