Dish Network DISH 1000.2, Руководство по установке

Страница: 3 / 22

Page 2
Quick Installation Instructions
Figure 1. DISH 1000.2 Antenna Installation Overview
1. Find Azimuth/Elevation/Skew angles for your location (instructions on page 3 and tables on page 10).
2. Find a location for the dish antenna with a clear line of sight and a sturdy mounting surface (page 3, step 1).
3. Mount the mast, making sure it is absolutely vertical (page 3, steps 2 and 3).
4. Assemble the dish antenna, setting the skew and elevation angles in the process. Use additional skew bolts for
skew angles greater than 110 or less than 70 (page 3, steps 4-6).
5. Mount the dish antenna on the mast and point the dish to the azimuth angle (page 4, step 7).
6. Run cables between the dish antenna and the receiver(s), leaving a service loop around the Mast Clamp (page 5,
step 1).
7. Using a peaking meter attached to the DPP 1000.2 LNBF
P
ORT
1
, peak the dish on 119°W using transponder 11
or higher for maximum strength. Tighten all bolts (see Table 1) and re-confirm maximum signal (page 5, steps 2-
5).
Note
: The 1000.2 Three-LNBF Bracket with three DP Dual (or DP Single) LNBFs can be used in place of the
Integrated Adapter Bracket and DPP 1000.2 LNBF.
8. Connect the receiver cable(s) to the DPP 1000.2 LNBF
P
ORT
1
(and
P
ORT
2
and
P
ORT
3
, as necessary)
(page 6, step 6) and receiver. Some restrictions apply when connecting Legacy receivers. See page 7.
9. Run
Check Switch
test and confirm 110°W, 119°W, and 129°W reception (page 6, steps 7-9).
10. Take a software download, if you didn’t already (page 7, step 10).
11. Run a
Check Switch
test and confirm 110ºW, 119ºW, 129° reception (page 7, step 11).
12. Install additional receiver(s), if necessary (page 7, step 12).
13. If applicable, connect a second satellite dish to the DPP 1000.2 LNBF’s
LNB I
N
port (page 8, steps 1-4).