Page 6
Table 1: Torque Values
Location
Torque Value (ft-lbs unless otherwise noted)
Mast pivot through bolt (ensure no mast deformation occurs during
tightening)
24 in-lbs
Mast locking nuts
12
Reflector mounting bolts
6
Clamp locking bolts
6
Clamp pivot through bolt (ensure no mast deformation occurs
during tightening)
24 in-lbs
Elevation adjustment locking nuts
12
Skew adjustment locking nuts
12
LNB and bracket attachment hardware
Handtight
Remove the temporary cable used for peaking the dish. Thread the cable(s) from the receiver(s)
through the LNBF arm and bracket. Connect these cables to
P
ORT
1
,
P
ORT
2
and
P
ORT
3
, as
applicable.
Note
: If using the Three-LNBF Bracket with DP Dual (or DP Single) LNBFs, refer to the section
Connecting to a Switch
on page 9 and the switch’s installation instructions for additional details.
Connect a cable from DPP 1000.2 LNBF
P
ORT
1
(or
P
ORT
2
or
P
ORT
3
) to a DISH Pro or DISH
Pro Plus (dual-tuner) satellite receiver’s
S
ATELLITE
I
N
connection(s). If a Legacy receiver is
present, it should be installed last.
To connect DISH Pro Plus (dual-tuner) receivers with a single cable, install a
DISH Pro Plus Separator as follows:
a. Connect a cable from the DPP 1000.2 LNBF output (
P
ORT
1
,
P
ORT
2,
or
P
ORT
3
) to the DISH Pro Plus Separator Input.
b. Connect cables between the receiver’s
S
ATELLITE
I
N
1
and
S
ATELLITE
I
N
2
to
S
ATELLITE
I
N
1
and
S
ATELLITE
I
N
2
respectively on the DISH Pro Plus
Separator.
You must use a DISH Pro Plus Separator in a single-cable/dual-
tuner receiver installation. A splitter or other device will not work in this configuration.
Tighten all indoor coaxial cable connections to the receiver only by hand. If you use a
wrench, you may over-tighten the connections and damage your equipment.
Connect the receiver(s) to the TV(s) and display the
Point Dish
screen (if not shown, for most
receivers, press
MENU-6-1-1
on the remote control).
Содержание DISH 1000.2
Страница 21: ...Page 20 Notes ...
