7.
Connect (car side) 8-pin plug,from step 6 to installation harness 8-pin
connector (See
Fig. 8
).
Fig. 8
installation harness
8.
Connect 8-pin plug from installation harness (See
Fig. 8
) to (radio side)
8-pin connector vacated in step 6.
Note:
These plugs/connectors are keyed and mate only with each other.
Proceed to “Pairing” section on page 6
Installation 2
: (Retaining functioning CD changer)
Radio removal required to gain access to connectors.
Remove trim ring and ensure the 2 tabs are centered at which point the radio
is pulled out the dash (grasping the cassette opening provides some leverage)
or push from rear. Proceed with step 1 below
1.
Disconnect factory CD changer plug from radio
2.
Connect factory CD changer plug to module 13-pin connector
3.
Connect module installation harness 13-pin plug (See
Fig. 9
)
to radio 13-
pin
connector
(See
Fig. 10
)
Fig. 9
Fig. 10
radio connector
4.
Proceed to step 3 on page 3 to complete the rest of the installation
