Introduction:
If looking to add
Bluetooth®
features to Porsche CR-1 or CR-2 radios you should
consider the A2DIY-CR12 kit. This revised easy to install kit is essential to adding
Bluetooth®
features to older vehicles while keeping everything stock. This
“triple
play”
module sounds great for
(1)
mobile conversations,
(2)
streaming Pandora,
Sirius radio, Apple music, audiobook, podcast and
(3)
CD changer retention or an
AUX input (for vehicles with changer). Use included smart remote to adjust
Smartphone: volume, track up/down/pause and more and can be mounted to
steering wheel or dashboard. In addition, an optional
“Fast charge’ USB
port helps
to keep devices charged while on the road. Thanks to the A2DIY-CR12 kit, Porsche
owners can update to
Bluetooth® 4.1
without changing original radio.
Works in vehicles with or without CD changer.
If retaining CD changer; skip to installation 2 on page 4.
See
Frequently Asked question
at the end of this guide for more details.
Installation 1
: (Without CD changer or not retaining it)
Radio removal required to gain access to connectors.
Remove trim ring and ensure the 2 tabs are centered at which point the radio is
pulled out the dash (grasping the cassette opening provides some leverage) or
push from rear. Proceed with step 1 below
Alert:
If vehicle has a CD changer but not retaining it, simply disconnect CD changer
plug from radio.
1.
Connect module installation harness 13-pin plug (See
Fig. 1
)
to radio 13-
pin
connector
(See
Fig. 2
)
Fig. 1
Fig. 2
radio connector
Fig. 3
2.
Connect installation harness 22-pin plug
(
see
Fig. 3)
to module 22-pin
connector (See
Fig. 4
)
