ElitePro Setup Guide
10
Step 4
Installation of the CD Printer
Install the CD Printer and connections per this step.
The autoloader is preset for the CD printer and all operating label software and drivers are included with
the installation CDROM.
Place the printer into the printer holding tray located at the top of the drive stack. Holding the printer with
hands on the left and right side, insert the front on the printer at an angle first, and then let the back
section “drop into” place. The printer should be securely inserted into the print holder tray and should be
completely level.
Plug in the USB printer cable provided with the autoloader into the rear of the printer and into the
USB001 connector on the rear of the autoloader.
Plug in the Printer mini din control cable (this is similar to a keyboard cable and has connectors on both
ends) into matching connectors in the rear of the printer and the rear of the autoloader.
Place the AC Power Adapter that was provided with the CD Printer next to the rear of the printer and
plug into a standard 115V AC outlet. Plug the other end into the power connector on the rear of the
printer. The printer will perform a basic internal test and then wait for additional commands from the
operator or the software.
Press the TOP button to turn the printer on. Use the lower button to open and close the tray.
Install Printer by allowing front section
to rest in place, then lower the
rear section into the tray.
Connect the Printer USB
Cable to the printer
Connect the Printer USB Cable
to USB001 port as shown
Connect the Printer DIN Control
Cable from the Printer to the autoloader
