Danish Interpretation Systems
User Manual
Manual 01 10 04479
14
4.
Enter
This button is used to enter the menus and
select a chosen value.
The markers < > around exit show the function
which can now be selected with the ENTER
button. If it is pushed again now, we will get
back to the master (default) display shown
above.
5.
< and >
These buttons are used to step the markers < >
left and right respectively for each push.
6.
LCD Display
Indicates
the
setting
of
the
system.
Rear panel connectors
1.
Mains Connector
Connection for mains power. The unit can
accept
the
following
voltages:
110V/130V/150V/220V/240V/260V depending
on the setting of the internal switch.
Before connecting the CU 4005/CU 4010
Central Unit to the mains, please check that the
voltage shown on the label close to mains socket
is in conformity with the voltage with which it is
to be used.
2.
Microphone Chain
Connector for the first DM/CM 4000 Unit
connected in the chain. A maximum of 50
microphone units can be connected at a time.
3.
Expansion of more CU 4005/CU 4010s
More central units are connected to these
connectors for systems with more than 50/100
microphone units. The MC 4000 Microphone
controller is also connected here. A maximum
of ten CU 4005/CU 4010 units and two MC
4000s can be interconnected.
The central unit with none or only the MC
4000 connected to the PREVIOUS connector
becomes the master unit.
4.
Microphone Output
The output delivers the signal from the
microphones independently of the Microphone
Volume setting on the front panel. Also, the
output is totally independent of the input signal.
The output signal is typically used for tape
recording or an external PA-system and is
nominal 0 dBm line-signal and –40dBm
microphone level respectively.