HOW TO
WARNING:
To reduce the risk of
personal injury - Unplug before cleaning or
servicing. Do not use vacuum without dirt cup
or fi lters in place.
CLEAN THE RINSABLE FILTER AND
CYCLONIC ASSEMBLY (CONT'D)
1
Remove the dirt cup. Twist the handle to remove
the top from the dirt cup. Gently remove the fi lter
from the the handle.
2
Tap clean into a trashcan.
3
All pieces are rinsable. Allow to dry 24 hours
before using.
4
Next pull cyclonic assembly out of the dirt cup.
5
Use the Dusting Tool to clean the cyclonic
assembly.*
6
When reassembling, ensure the cyclonic
assembly is aligned and twist the lid into the
locked position.
CLEAN THE EXHAUST FILTER
WARNING:
To reduce the risk of personal
injury - Unplug before cleaning or servicing. Do not
use vacuum without dirt cup or fi lters in place.
1
Push the tab on the front of the cover to pivot out.
2
Pull out the fi lter, rinse dirt from both sides,
and let air dry for 24 hours before reinstalling
or until dry.
3
Put the dry fi lter back. Now line up the fi lter
cover with the bottom tabs fi rst and then snap
back into place.
CLEAN THE BRUSHROLL
CAUTION:
To reduce the risk of injury
from moving parts - Unplug before servicing.
1
Turn your vacuum over. Use a Phillips
screwdriver to take off the 6 screws. Remove the
bottom plate.
2
Clean the brushroll.
3
Slide on belt with the lettering on the outside.
REPLACE THE BELT
CAUTION:
To reduce the risk of injury
from moving parts - Unplug before servicing.
1
Turn your vacuum over.
Use a Phillips screwdriver to take off the 6
screws. Remove the bottom plate.
2
Then take off that old belt. Slide on a new belt
with the lettering on the outside.
A
B
3
C
Pull on belt to slip around the brushroll in area
without bristles (A) and metal pin (B). Each end
of the brushroll will fi t into pockets on each
side of the nozzle (C). Put the plate back on and
screw together.
LUBRICATION:
The motor and
brushroll are equipped with bearings
which contain suffi cient lubrication
for their lifetime. The addition of lubricant could
cause damage. Do not add lubricant to motor or
brushroll.