17
Preparing the appliance
GB
2
Preparing the appliance
2.1
Unpacking
1.
Unpack the appliance and all its accesso-
ries.
2.
Check the contents for completeness and
possible damages.
2.2
Setting up
1.
Place the base on a solid, dry and level
surface away from sources of water and
heat.
2.
Put the lid onto the appliance.
2.3
Fitting the lid of the water kettle
1.
Put the lid onto the water kettle as shown
in fig. (Fig. 2/1.).
Push the lid with its two notches onto the
two studs on the edge of the water kettle
(Fig. 2/1.).
2.
Push the lid backwards until your hear and
feel it snap into place. (Fig. 2/2.).
2.4
Connecting
1.
Unravel the power cord from the base only
as far as necessary.
2.
Fix the power cord by pressing it back into
the exit opening of the base.
3.
Insert the mains plug into a socket with
ground/safety contact.
The display of the temperature set-
ting will now show "
EE
".
This indicates that the base is al-
ready connected to the mains, but
the appliance has not yet been put
onto the base.
4.
Put the appliance onto the base so that
the plug engages the contacts.
The set temperature indicator will
now show a blinking "
OF
".
Your appliance is now ready to use.
ATTENTION:
Always transport/send the appliance in its
original packaging to avoid transport dam-
ages. Keep the packaging for such an
event.
Dispose of no longer needed packaging
material according to the applicable regula-
tions of your country.
NOTE:
Immediately contact your dealer if you have
found damage resulting from transportation.
2.
1.
2
ATTENTION:
Only operate the appliance if your mains
voltage is the same as that indicated on the
appliance's nameplate. Wrong voltage can
destroy the appliance.
WARNING:
Danger of injury!
Run the cord in such a way that it does not
constitute a hazard.
ATTENTION:
Avoid heating the empty pot, as this might
damage the appliance in spite of its auto-
matic shut-off feature.
NOTE:
If the appliance is accidentally switched on
empty, the overheating-protection will auto-
matically switch it off (for this, also refer to
Z
Chapter 3.4, "Automatic switch-off"
). Let
the appliance cool off completely before fill-
ing it with water or food again.
Aquagrad mit hotpot.book Seite 17 Montag, 13. Dezember 2010 10:26 10
