DirecTV W-DCCK, Руководство пользователя

Страница: 31 / 34

TM
DIRECTV Field Operations Training
©DIRECTV 2011
DIRECTV W-DCCK
Version 1.3.0
31
Notes DIRECTV Wireless Cinema Connection Kit
Appendix
Wall Mount Instructions
�
| POWER LAN
� Coax Sta
tus
� Coax NT
WK
�
WLAN
� AP|STA
�
|
POWER
LAN
� Coax Sta
tus
� Coax NT
WK
�
WLAN
�
AP|STA
Figure 3
Tabletop Installation
The DIRECTV CINEMA™ Connection Kit (DCCK) unit should be placed on the baseplate (Figure 1) by inserting the baseplate
knobs into knob holes A & B (Figure 2). Shift the baseplate to the left to tighten onto the unit as shown in Figure 3.
Wall Mount Installation
Wall mount installation options:
1.
Wall mount the unit with the baseplate.
2. Wall mount the unit directly on the screws.
Two M4 x 20mm pan head screws (thread type: tapping) and expansion anchors (Figure 4) are included for wall mounting.
You can call DIRECTV for detailed information.
* Horizontal orientation using points C & D (Figure 5‐1) or vertical orientation using points C & D (Figure 5‐2).
* Suitable masonry screw expansion anchors may be required if attaching to stone/brick wall.
y
To mount the unit on a wall, follow these instructions:
1. Ensure that the mounting location is free from hazards (electricity cables/pipes etc).
2. Decide orientation: horizontal or vertical.
3. Drill two pilot holes 26mm (about 1.0 inches) deep using a 3.6mm (about 0.14 inches) drill bit.
à
For horizontal orientation, the two pilot holes must be level and spaced 70mm (about 2.76 inches) apart
horizontally.
à For vertical orientation, the two pilot holes must be vertical and spaced 70mm (about 2.76 inches) apart vertically.
à
When mounting on a stud partition wall at least one of the mounting screws must be attached to a wooden stud.
4. Decide wall mount method:
à
With baseplate: Place the screw expansion anchors into the drilled holes
Æ
drive the screws through the baseplate
and fasten to the wall
Æ
mount the unit to the baseplate properly. See Figure 6.
à Without baseplate: Place the screw expansion anchors into the drilled holes Æ drive the screws into the wall Æ
adjust the screws to expose approximately 5.5 inches of the screw to mount the unit properly. See Figure 7.
5. Make sure that the correct slots of knob holes C and D (Figure 5) are used depending on orientation.
mm
3.75 ~ 4.25mm
20
7mm
25mm
2.9mm
8mm
Screw
Expansion Anchor
Figure 4
Figure 5
C
D
Figure 5-1
C
D
Figure 5-2
C
D
Figure 6
1
3
2
Figure 7
1
3
2