DirecTV W-DCCK, Руководство пользователя

Страница: 13 / 34

TM
DIRECTV Field Operations Training
©DIRECTV 2011
DIRECTV W-DCCK
Version 1.3.0
13
Notes DIRECTV Wireless Cinema Connection Kit
Installing a Wireless Cinema Connection Kit
Direct Ethernet Connection
1. Using the supplied Ethernet cable, connect one end of the Eth-
ernet cable to the Ethernet port of the W-DCCK device.
2. Connect the other end of the Ethernet cable to the Ethernet
port on the back of the DIRECTV Receiver. If the DIRECTV Re-
ceiver has two Ethernet ports, connect the cable to the upper
port labeled “ETHERNET 1”.
3. The POWER and Activity LEDs on the W-DCCK light up. Wait for
the POWER LED to stop flashing.
• If the LEDs do not light up, go the Troubleshooting section.
4. Perform one of the following steps:
• WPS Connection to Router Established: go to the section
below, Complete Wireless Protected Setup.
• WPS Connection to Router Not Supported or Established:
go to the section below, Manual Wireless Setup.
Note: For each receiver that requires an internet connection, a W-
DCCK is required.