(2)
Record the
signal level
(3)
Set the plastic dial to zero (0) by hand.
(4)
Using a ½ inch nut driver, rotate the
fine tune adjustment bolt 2 full turns
“counter clockwise.”
(5)
Record the signal
level
(6)
Rotate the bolt “
clockwise
” counting
turns as well as the fractions until the
same signal level is achieved.
Note:
This may require 5 to 7 turns.
(7)
Divide the number by two (2).
Note:
You can
use the division chart below.
(8)
Turn the dial, not the
screw back to zero.
(9)
Rotate the screw “
counter clock
wise
” by the divided amount of turns.
(10)
Tighten down the Azimuth bolts and verify signal via the IRD
(Make sure that the the SWM Integrated LNB screws are installed)
Complete Part 2 before
Fine Tuning Azimuth
If good signal
from the IRD, the
Peaking Process
is complete
(1)
Set Meter to 101° -
Super Buddy
LNB 1,
BirDog
DIRECTV SWM 101
Accutrac
Specific
(LNB 1, 13v w/o 22KHz )
Accutrac III
– Satellite Select
Ka @99, Ku @ 101
Digisat III
Specific
( 13v w/o 22KHz )
