Version 1.0.0 12/16/2016
C. W
IRELESS
V
IDEO
B
RIDGE
The WVB2 survey is important to determine placement of
clients (C61W). As part of the initial WVB survey, the technician determines a central
location to place the WVB
determining the following:
•
Determine the Genie server (HR44/HR5
•
Determine the client locations
•
Determine the location of the WVB
The WVB2 must be installed in a vertical position using the permanently
attached foot/pedestal.
negative impact on the distance the clients can be from the WVB
Do not place the WVB
The following is the WVB
new installs and upgrades.
1) The WVB
instructed.
2) Setup the wireless clients (C6
If the C41W, C6
to its final mounted
WVB.
3) Connect the wireless client (
wireless client (
Video Bridge” screen. (
“Continue” op
“Connect Now” option
they may proceed wi
•
If the client signal strength is poor, the Connect Now
disabled.
User Manual –
Wireless Video Bridge Gen 2
Page 17
RIDGE
S
URVEY
(
AKA
B
EACON
M
ODE
)
survey is important to determine placement of the WVB2
1W). As part of the initial WVB survey, the technician determines a central
location to place the WVB2 to service the Wireless Clients (C61Ws). This is done by
determining the following:
etermine the Genie server (HR44/HR54) location
Determine the client locations
Determine the location of the WVB2.
must be installed in a vertical position using the permanently
attached foot/pedestal. If the WVB2 is lying flat on its side, it can have a
negative impact on the distance the clients can be from the WVB
Do not place the WVB2 on the floor as it may be easily knocked on its side.
The following is the WVB2 survey/Beacon mode procedure. This procedure covers both
new installs and upgrades.
The WVB2 is not to be connected to the SWiM/MoCA network
instructed.
Setup the wireless clients (C61W) in the location they will be used.
C61W is to be mounted behind the TV, it should be placed
its final mounted position as possible to fully verify signal quality
Connect the wireless client (C41W, C61W) to the TV and p
wireless client (C41W, C61W) will boot up to the following “Connecting to
Video Bridge” screen. (C41W, C61W with older software will have a
“Continue” option, and C41W or C61Ws with new software will have a
“Connect Now” option). The user need not wait for this screen to display;
they may proceed with the next step.
If the client signal strength is poor, the Connect Now/Continue
Wireless Video Bridge Gen 2
the WVB2 and Wireless
1W). As part of the initial WVB survey, the technician determines a central
1Ws). This is done by
must be installed in a vertical position using the permanently
is lying flat on its side, it can have a
negative impact on the distance the clients can be from the WVB2.
on the floor as it may be easily knocked on its side.
survey/Beacon mode procedure. This procedure covers both
is not to be connected to the SWiM/MoCA network until
1W) in the location they will be used.
it should be placed close
position as possible to fully verify signal quality from the
1W) to the TV and power on. The
the following “Connecting to
1W with older software will have a
1Ws with new software will have a
). The user need not wait for this screen to display;
/Continue option is
