16
Directed Digital Solutions HYUNDAI4
© 2017-10-12 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 17 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note
: To skip the transponder programming and use convenience features only, press the
programming button 5 times. When the LED turns ON solid orange, proceed to step 4.
Must be connected LAST
&
Solid
4
Important!
Do NOT press the brake pedal.
Make sure the key is inside the vehicle.
Press
the Push-to-Start (PTS) button twice to turn the
ignition ON.
Do NOT press the
brake pedal
5
The LED flashes orange indicating ignition was sensed, then turns ON solid green for 3
seconds.
Note
: When skipping the transponder programming, the LED flashes orange, then turns ON
solid orange for 3 seconds, and shuts OFF.
Flashes
Solid x
3 secs
Solid x
3 secs
&
&
6
Press
the PTS button once to turn the vehicle ignition OFF once the module is successfully
programmed.
7
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
8
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 20.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.