59
DS4+ TL10
© 2017-05-29 Directed. All rights reserved.
D2D 1.0/2.0 port configuration
• The 3 D2D ports should be configured as follows:
• The 2 black D2D ports are internally protected and connected in parallel. Devices connected to both ports need to be
configured with the same communication protocol, which in this case is D2D 2.0. This is where the Control Center (antenna)
and 8504D Shock Sensor should be connected.
• The single white D2D port should be used for SmartStart and will require to be configured for D2D 1.0 functionality.
• All ports can be configured for D2D 1.0 and 2.0; however, if the device is not configured accordingly as well, it will not be
recognized.
• All ports need to be configured via the web, but the above is the recommended installation configuration.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 60 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the DS4+,
EXCEPT
the 12-pin main power harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only,
press
the
programming button 5 times. The LED will turn orange then proceed to step 4.
Must be
connected LAST
&
Solid
4
Insert
and
turn
the key to the ignition position.
Wait for the LED to turn on solid green for 3 seconds, and turn OFF.
Note:
If transponder programming was skipped, the LED turns ON solid orange
for 3 seconds then shuts off when programming is done.
&
Solid
x3sec
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
Off
&
5
Turn
vehicle ignition OFF once the module is successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
7
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 63.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.