v5.3 J2428
© 2005 Directed Electronics, Inc.
OEM S
ERIES
Remote Control Car Starter Installation Manual for Models 28624T and 28628
PLEASE READ COMPLETELY BEFORE BEGINNING
Congratulations on your purchase of the AutoCommand
®
OEM Series Remote Car Starter. The AutoCommand
®
OEM Series Remote Car Starter system allows you to start the car
by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand
®
OEM Series is for
automatic transmission/fuel injected vehicles only
. It is an extremely sophisticated system with multiple built-in safety and security
features.
AutoCommand
®
OEM Series Car Starter:
• Will start your car by remote control, and run the heater, defroster, or
air conditioner to warm up or cool down the car.
• Is designed to start the car if it is in park, and only if the hood is
closed.
• Has Lock, Unlock and Trunk keyless entry features.
• Will attempt to start the car for up to six seconds, but no longer (to
avoid damage to the starter motor). Should the car not start, or if it
stalls after starting, the remote starter will make two further attempts
to start it.
• Has alarm functions including starter kill which becomes active when
the doors are locked with the remote control.
• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes (programmable) if
you forget to come out to your car.
• Will shut off if the brake pedal is pushed, the hood is opened, or the
transmission is shifted out of park - unless the key is in the ignition and
in the “run” position.
• Allows you to remove the key while leaving the car running with the
doors locked for up to 10 or 15 minutes utilizing the Quick Stop™ Op-
tion. (See Separate User Tip Sheet)
• Starts the car automatically whenever the temperature drops below
0
°
F (-18
°
C), or if the battery voltage drops below 11 volts when the
Cold Start™ Option is used. (See Separate User Tip Sheet)
• Has the “Daily Start™” feature which allows the vehicle to be started
at the same time the following day. (See Separate User Tip Sheet)
• Is quality engineered and microprocessor controlled to provide many
years of reliable use.
• Comes with a Limited Lifetime Warranty.
* For free vehicle specific wire information, consult
our website at www.designtech-intl.com
www.designtech-intl.com • www.directed.com • 800-876-0800
Parts List included with the AutoCommand
®
OEM Series Unit:
We highly recommend that all connections be soldered for reliability.
Drill with1/4”and 5/16”
drill bits
Electrical Tape
Soldering Iron
Test meter
Pliers
Screwdriver
Wire Cutters/Strippers
Tools required to install the AutoCommand
®
OEM Series Unit:
6 Power and Ignition wires
Antenna
Remote Starter
Receiver Module
Transmitter
Siren (Model 28628 only)
Control Harness
(10 position)
2 Relays with relay harnesses
(Model 28628 only)
Shock Sensor
(Model 28628 only)
Alchohol
Pad
Ring Terminal
Plug-In LED
2 Protected by
DesignTech Labels
Alcohol Pad
Green 30 A Fuse
On/Off Control Switch
Warning Label
Following parts included in plastic baggy
3 Pin Door Harness
Yellow Butt Connector
2 Cable Ties
Hood Pin Switch Set
Wiring Diagram