User guide
P.9
Panic
Mode
Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the STOP button
for more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start, the
engine will shutdown automatically before setting off the horn. You can stop the horn by pressing:
(this will lock your doors and deactivate panic mode), or
(this will unlock your doors and deactivate panic mode).
Furthermore, the panic mode can be stopped by activating Valet Mode (page-8)
* Panic Mode will automatically shut down after 30 sec.
Quick
Lockout
TM
(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick Lockout is only
available when panic mode has been set off.)
Cold
Weather
Mode
If the vehicle has a manual transmission, Ready mode (page-5) should be set before entering Cold
Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs for
3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends after
24 hours (or 12 starts).
To enter Cold Weather Mode:
•
Press and hold the button for at least 3 seconds
•
The parking lights will flash for 2 seconds, pause, then flash 3 times.
To exit Cold Weather Mode, do any one of the following actions:
•
Open the hood.
•
Start the engine by remote.
•
Turn the ignition key to the IGNITION ON (RUN) position.
•
Press and hold the button until the parking lights come ON for 2 seconds, pause,
and then flash once.
If Safe Start is enabled, you can activate Cold Weather Mode by:
•
Pressing and releasing the button, then, pressing and holding the button until the
parking lights flash 3 times.
To verify whether the system is in Cold Weather Mode (automatic transmissions only):
•
Press the brake pedal:
•
If the vehicle is in cold weather mode, the parking lights will remain ON while the
brake pedal is pressed.
Extended
Run
Time
With the vehicle running under a remote start, pressing and holding the button for more than 3
seconds will reset the run time counter to zero and restart the run time cycle from the beginning.
•
The horn (if programmed) will honk once;
•
The parking lights will flash slowly 3 times then remain lit.
To stop the vehicle at any moment, simply press the STOP button. This procedure can only be
carried out once per remote start.
