User guide
P.7
Remote
Starter
Features
Remote
Door
Locks
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To lock your doors and arm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
2.
The parking lights will flash once to confirm that the doors have been locked
To unlock your doors and disarm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
2.
The parking lights will flash twice to confirm that the doors have been unlocked.
Remote
Trunk
Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button for 3 seconds on the remote transmitter.
Idle
Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
Activating Idle mode (Automatic transmission):
1.
With the engine running, make sure to release the brake pedal and press the
,
or button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the icon to activate Idle mode, Turbo mode
or Ready mode.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle. All doors, the hood and trunk should be closed
4.
Press the
button to lock the doors, to arm the starter kill and to arm the alarm. The
engine will be kept running at idle speed.
a.
When re-entering the vehicle, the user must reinsert the key into the ignition and
turn it to the ON position (not Crank) without pressing on the brake.
b.
Once the key is in the ON position, press on the brake pedal to put the
transmission in gear.
c.
Drive off.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page-5); at the last step, the
button is pressed instead of the other
buttons. This will lock the doors, arm the system and leave the engine running.
NEW FEATURE – Push-To-Start Idle Mode
This feature is a variation of “Idle mode”, but made specifically for Push-To-Start vehicles, with
automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the
same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the
engine is running;
