background image

 

User guide 

P.3 

Government

 

regulations

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation. 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates and can radiate 
radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures: 
 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is 
authorized only on a no-interference, no-protection basis; in other words, this device must not be 
used if it is determined that it causes harmful interferences to services authorized by IC. In 
addition, the user of this device must accept any radio interface that may be received, even if this 
interference could affect the operation of the device. 
 
Warning! Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate this device. 

Introduction

 

 

This is a state-of-the-art remote car starter system. The system is packed with advanced features 
such as priority access to the driver’s door (commodity features), the Safe Start children safety 
feature and SmartStart™. 
SmartStart™ is a groundbreaking technology that enables your remote starter features to be 
accessed by your smartphone. Features include keyless entry, trunk release, panic, remote 
start/stop toggle and alarm notifications

1

Note: SmartStart™ must be professionally installed. For 

more information, see your nearest authorised Directed Canada dealer. 
With many advanced functions, this product will satisfy any one of your expectations from high-end 
commodity and security systems, without neglecting any standard feature commonly offered by 
entry-level starters. 

 

 

                                                                        

1

 Certain conditions apply. See your authorised Directed Canada dealer. 

Содержание AS-1775















Отзывы: