Operating Instructions
Articulating headrest may be adjusted to desired
position by pulling forward or pushing back.
Operating Instructions for Blow-Molded Table
To Operate
1
. Underneath each arm, pull down and hold button
(fig. 2 A & B)
and slide lockout keys forward on both
sides (D).
2
. Pick up table by circular table arm and slide into
receiving tubes in front of each arm.
3
. Table can slide on and off by keeping lock/lockout
key forward.
4
. Table can be locked into one of five positions. Pull
down the pull button, hold the pull button and slide
the key backwards. Repeat on the other arm and
move that key backwards. Table will now be locked.
Storage
The blow-molded table stores in the small round tube
underneath the left armrest, leaving the tabletop
facing out.
Maintenance & Cleaning
Always ensure the product is functioning properly prior to each use.
Every Three Months:
• Check and Clean Casters
• Tighten Nuts
• Check Brakes on Casters
• Check and Clean Lock Recline Mechanism
For upholstery maintenance and stain removal, the following hints will be helpful
:
Ordinary Dirt:
Wash with warm water and a mild soap or detergent.
Stubborn Dirt:
Using a soft bristle brush, follow direction above.
Ground-In Dirt:
Scrub with a mild cleaning solution until clean.
Chewing Gum:
Scrape carefully: remove with kerosene or naphtha.
Nail Polish and Remover:
Blot immediately to prevent damage.
Tars, Asphalt, Creosote:
Remove to prevent staining. Clean with kerosene or naphtha.
Caution:
When using kerosene or naphtha, do so in a well ventilated area and keep away from fire and flame.
Paint, Shoe Polish, Heel Marks:
Remove immediately! Use a white cloth dampened in kerosene, naphtha or
turpentine. Do not use paint remover or liquid brush cleaners.
Ball Point Pen:
Blot immediately with a white cloth dampened in water or mineral oil.
Waxing and Refinishing:
Improper wearablilty. Use any quality paste wax.
A diluted solution of 10% (or less) bleach or Clorox may be used when cleaning this chair.
Caution:
Do not operate recliner by applying force or
pressure to the legrest. Avoid placing hands
or legs in creases near recliner mechanism.
Operating Instructions
(cont.)
Maintenance & Cleaning
PVc Push
Handle (e)
right Pull
Bottom (A)
Articulating Headrest (F)
table (c)
left Pull
Bottom (B)
lockout
Keys (D)
Figure 2