Direct-Lift Pro Cycle XLT, Установка-Безопасность-Эксплуатация-Техническое обслуживание

Страница: 7 / 12

7
Observe and heed SAFETY, CAUTION and WARNING labels on the lift.
1. Lift must be fully lowered and service bay clear of all personnel before the vehicle is brought on lift.
2. Motorcycle Loading:
A. Put motorcycle onto lift. Be sure motorcycle is centered on lift from side to side.
B. Stop when motorcycle front wheel is in wheel clamp/stop.
C. Secure motorcycle to lift using clamps and straps.
IMPORTANT
Straps MUST be used to secure motorcycle. Clamps are for temporary holding only.
4. To Raise Lift:
A. Release lock handle from lift.
B. Actuate raise button on foot pedal.
C. Raise to desired height. Note: lock should be clicking into place as lift is raised. If not, stop. Lower lift
to ground then repeat entire step 4.
D. Actuate lower button on foot pedal and lower lift onto locks.
CAUTION
DO NOT go under lift or vehicle if locking latches are not engaged.
6. While Using Lift:
A. Avoid excessive rocking of vehicle while on lift.
B. Using cycle jack can allow for access to rear wheel service.
7. To Lower Lift:
A. Remove all tools or other objects from lift area.
B. Actuater raise button on foot pedal to raise lift off locking latches.
C. Rotate lock back up under lift and lock into place.
D. Actuate lowering button on foot pedal to lower.
8. Remain clear of lift when lowering vehicle. Observe pinch points.
9. Remove motorcycle from lift.
10. If lift is not operating properly, Do Not XVHXQWLODGMXVWPHQWRUUHSDLUVDUHPDGHE\TXDOL¿HGOLIWVHUYLFH
personnel.