Direct Bikes DB50QT-A, Руководство пользователя

Страница: 22 / 35

General ‘walk around’
Before use please go around the scooter and check that all nuts and bolts are tight
and secure and that there are no loose parts.
Starting the scooter
Before starting you need to put petrol in. The petrol cap is either located under the
seat or at the rear of the foot well under a locked flap. These scooters use normal
unleaded (90> octane). You must not over fill with petrol as any spillages will
damage the paint and may spill onto a hot engine creating a hazard. Make sure the
scooter is on the main centre stand. Put the key in the ignition and turn clockwise
until the ignition lights come on. Hold the rear brake and press the ignition button
on the right hand switchgear. Keep the button pressed in until the scooter starts but
for no longer than 5 seconds if it does not. Wait 10 seconds before trying again. You
should not need to touch the throttle as the carburettor has an auto choke. These
scooters are also fitted with a manual kick start on the left side of the engine. To
operate this you still need to have the rear brake applied. Push the kick-start pedal
down slowly until there is resistance in the engine then release until the pedal
returns to the top. Push the pedal all the way down briskly and release. Repeat as
necessary until the scooter has started. DO NOT REV THE SCOOTER WHILST IT
IS ON THE STAND. The scooter is fitted with an auto clutch and could go forward if
it comes off the stand and cause injury.
21