background image

3 OF 3

®

Toll Free: 877.817.6028 | Fax: 415.592.1596 | www.DiodeLED.com | [email protected]

© 2019 Elemental LED, Inc. All rights reserved. Specifications are subject to change without notice.

IG070319-2.0

TOUCHDIAL

 RGB(W) Wall Control INSTALL GUIDE

TOUCHDIAL

 RGB(W) Wall Control

INSTALLATION GUIDE

MOUNTING

1. Place Base Mount on surface where desired, ensuring it is 

level.

2. Screw Faceplate to Mount and surface using included Screws.

3. Place Remote into Faceplate, and connect to Mount using 

magnet.

Symptom

Common Cause

Control won’t 

function

•  Check for dead batteries.
•  Remote must be turned on for 

operation.

Master receiver 

does not sync with 

remote

•  Ensure  function  is  set  to  MASTER         

(1 pin) - See Syncing Note or 

TOUCHDIAL Receiver Installation 

Guide.

•  If still not syncing do following: 1) 

Turn off main power to receiver and 

turn back on. 2) Reset receiver by 

long pressing LEARNING KEY for 

5 seconds until LED flashes. 3) Re-

sync receiver to control.

TROUBLESHOOTING

See TOUCHDIAL Receiver Install Guide for more troubleshooting tips.

BATTERY REPLACEMENT

1. Remove Remote from 

Mount.

2. Open Battery backplate on 

Remote.

3. Insert new battery.

4. Place Remote back into 

Mount.

TOUCHDIAL RGB(W) WALL CONTROL SPEC 

SHEET 

F

or full specifications.

TOUCHDIAL RECEIVER SPEC SHEET & INSTALL

GUIDE

F

or full specifications and installation instructions.

ADDITIONAL RESOURCES

CR2032

Battery

RGB

W

Отзывы: