DWG2000-8G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
43
is Yes, the Caller User ID that send to B will be A, when "Send Original
Caller ID for PSTN Incoming" setting is No, the caller User ID that sent to
B will be C(except for anonymous outgoing )
DTMF
DWG2001/DWG2000-4G/DWG2000-8G support RFC2833 and SIGNAL
two ways. DTMF INTERVAL range is 50 ~ 800ms, DTMF VOLUME can
use the default Configuration
Enable STUN
（
Simple Traversal of UDP over NATs
，
NAT’s UDP simple cross) is a
network protocol. It is allowed to stay behind the NAT (or multiple NAT)
client part to identify their clients’ public address, found himself after
what Type of NAT and NAT for a particular Channel is bound to a local
Internet terminal Channel. This information is used for two host to set up
UDP communication behind the same NAT router. The agreement
defined by the RFC 3489
CLID Mode
Select the name under the special needs , the most common way is use the
default User ID
Allow Outgoing Calls
without Registration
Refer to "SIP Configuration" -> "Is register" . If "Is register" setting is no,
this option need set Yes ,to avoid that the devices can not call out
Allow Incoming Calls
without Registration
Refer to "SIP Configuration" -> "Is register" . If "Is register" setting is no,
this option need set Yes ,to avoid that the devices can not call in
Allow Anonymous
Outgoing Calls
The incoming anonymous calls will be rejected
Use # as End Key
In General, SIP phones are based on # as the end, if this option is set to
No, the dial-up will end expires dial-up time
Inter digit Timeout
Bit of between the dialing time ,over the time will be seem as end of dial
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
