DWG2000-8G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
45
Keep alive
Interval
Used to keep communicate between equipment and the SIP server that make
the device is in the best available Registered. In general, using the factory
default values
4.11.4 Port Configuration
Port Configuration is used to configure ports’ gain, Off-hook Auto-Dial, etc.
Figure 4-11-4 Port Configuration
Table 4-11-3Description of Port Configuration
Port Configuration
Used to configure ports’ gain, Off-hook Auto-Dial, etc.
ALL ports register
used same user ID
The default is not, each SIP account, if set yes ,all the port will use user
ID of port0, when the call ring in sequence
SIP User ID
Is the account used for registration, equipment port's unique identifier,
"Authenticate ID" is equivalent to show the name, "Password" is register
Password, which no passward can no fill, the details please contact the
service provider
Tx Gain
Refers to the call volume that from himself during a call to the end users,
adjust the "Tx Gain" will affect the voice volume of the end user, the
default value is 0
Rx Gain
Refer to the call volume from the remote end user to ourself volume,
adjust the "gain acceptance" will affect the voice volume we will heard,
the default value is 0.
Offhook Auto-Dial
Hotline service.when PSTN part client calls to this port,will auto forward
to the hotline User ID. If no need this feature, just left it blank
Auto-Dial Delay Time
Offhook Auto-Dial delay time, the range is 0-10 seconds
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
